networx security command center power down changing battery

#Networx security command center power down changing battery install#

It will take up to 24 hours for the new battery to be fully charged, so don’t be concerned if the error message doesn’t cancel out immediately. You may need to clear the error message on the alarm keypad. When you are finished connecting the new battery turn the power to the alarm system back on, by either plugging the system back in or turning the electrical breaker back on. Be very careful to replace the + (positive) and – (negative) wires to the correct terminals on the new battery. Next, place the new battery in its place and reconnect the wires. Remove both wires from their terminals and remove the old battery. When disconnecting the old alarm system battery note which wire is attached to the + (positive) battery terminal and which wire is attached to the – (negative) battery terminal. In this case you will need to go to your home’s breaker box and shut off the power to the alarm system. However, some systems are hardwired to the home’s electrical wiring. There is usually a power supply plug near the wiring box. When changing your alarm system’s backup battery, first, disconnect the power supply to the alarm system. The reason for this is that both of these replacement batteries have longer run times, are a better quality and have longer warranties. For example we often recommend model number TLV1250F1 for customers who are replacing a 4AH batter, and TLV1272F1 for customers who are replacing a 7AH battery. When purchasing a replacement battery, it’s recommended you get one as close to the original rating as possible. For example, DSC alarm batteries are often “ BD412 (12V 4AH)” or “ BD712 (12V 7AH)” The battery’s model number will indicate its size. Make note of the numbers on the battery, in most cases alarm batteries will be 12V and either 4AH, 5AH, 7AH or 8AH. When you locate the alarm system’s wiring cabinet, open the door and locate the rectangular shaped battery.

#Networx security command center power down changing battery install#

Most wired alarm systems install the back up battery in a metal cabinet in the basement or wiring closet. Replacing your alarm system battery is a simple task that can be completed by the home-owner and doesn’t require a service call, as long as you follow some simple guidance.įirst you will need to check the size and shape of the current battery, so you can ensure you are purchasing the correct replacement battery. Your system continually charges the backup battery, but eventually the battery will begin to lose its ability to maintain the system on its own. The purpose of the backup battery is to keep the alarm system running in the case of a power outage. You need to replace the battery in your home alarm system if your low battery indicator is warning that your battery is low.